Can Bus Resistor CBW1 Adjustable

CAN-BUS resistor CBW1 with DIP switch.

Newly developed HIGHSIDER CAN-BUS resistor CBW1 fits most vehicles with a CAN-BUS system.

The resistor CBW1 provides a required electrical load for your vehicle. If the dip switches are set correctly, it will not cause an error message in the cockpit when accessory indicators are used.

In addition, the system is fail-safe. This means that if the accessory indicators fail due to an electronic defect, an error message is immediately displayed in the cockpit.

Up to 2 channels can be operated. (e.g. rear left and right)

The CBW1 can also be used on vehicles with original LED indicators.

The following resistance values can be set:

• 150 Ohm
• 170 Ohm
• 240 Ohm
• 300 Ohm
• 400 Ohm
• 600 Ohm
• 1200 Ohm

Measurements:

• Height = 11mm
• Width = 31mm (without straps)
• Width = 46mm (with tabs)
• Length = 40mm
• Cable length = 200mm with pins

Connections:

• Yellow = input channel 1 (+)
• Orange = Output channel 1 (+)
• Blue = Input channel 2 (+)
• Red = Output channel 2 (+)
• Grey = Input ground (-)
• Black = output ground (-)

Scope of delivery: 1 piece

Notes: - Up to 2 channels
can be operated - The connection is explained in detail in the
operating instructions!

Note: This product is not assigned to a specific vehicle - please check if this item fits and/or is needed.